Why this matters
Keep this Broken Glass Cleanup talk tied to the job in front of the crew. Cover hidden shards, cuts and improper disposal, then confirm the setup and who is responsible for the key controls. Material handling becomes dangerous when the load blocks vision, shifts unexpectedly, exceeds the planned handling method or is stored where it can roll, fall or trap someone. Plan the route, grip, team/lifting aid and final storage before the material starts moving.
A scenario to discuss
During Broken Glass Cleanup, the material turns out heavier, longer, more flexible, or more top-heavy than expected. The crew can probably muscle it through. What lifting aid, additional person, or different method should be considered instead?
Before work starts
- Confirm load weight/shape and select the lifting aid, cart, team size or handling method before moving it.
- Walk the route and remove trip hazards, protect finished surfaces and control doors/traffic.
- Prepare stable storage/landing space before the load leaves its starting point.
- Identify the actual exposure first, then select PPE that is appropriate and compatible with the task.
- Inspect PPE before use and replace damaged, contaminated or poorly fitting equipment.
Common failure points
- Starting the move before there is a clear destination and route.
- Handling a load that blocks vision or shifts without enough people or a mechanical aid.
- Stacking material where it can roll, tip, slide or obstruct emergency/access routes.
Safe work sequence / controls
- Identify the actual exposure first, then select PPE that is appropriate and compatible with the task.
- Inspect PPE before use and replace damaged, contaminated or poorly fitting equipment.
- Wear protection correctly for the entire exposure, including setup and cleanup when hazards remain.
- Keep PPE clean and stored so it does not become damaged or contaminated between uses.
Stop and reset the plan if...
- The load weight, route, center of gravity or handling method is uncertain.
- Storage, racks, cribbing, carts or landing areas are unstable, overloaded or blocked.
- The crew cannot maintain visibility, communication or clear hand/foot placement during the move.
Questions worth asking the crew
- What does this load weigh, where is its center of gravity/awkward side, and what does that mean for the number of people or equipment we need?
- What route are we using, and where will vision, footing, doors, stairs, traffic, or other workers make the move harder?
- Who is calling the move, and what lifting aid/cart/team method are we using instead of trying to muscle through a bad position?
- Where will the material be set down or stored so it cannot roll, tip, slide, blow over, or block access?
- Has anyone had a load shift, block vision or become harder to carry than expected? Where is the safest set-down point on this job?
Make it real on the job
Walk the move from pickup to set-down and identify the pinch points and where vision will be blocked.
Close the talk
Before the crew starts, everyone should be able to explain the hazard, point to the control being used today, and name the condition that would make the work stop.
Related authoritative reference
29 CFR 1926.95 - Criteria for Personal Protective Equipment · Open reference ↗
This is a practical discussion guide, not a substitute for required training, a competent person, permits, manufacturer instructions, employer procedures, or applicable federal/state/local requirements. Adapt it to the actual task and conditions.
