Why this matters
Use this leader guide before conduit bending, handling & stored energy work to review the real setup, the controls that need to be in place, and the conditions that should stop the task. Electrical incidents often happen when a circuit is assumed to be dead, temporary wiring is damaged or overloaded, or the work moves closer to energized parts than planned. Treat verification, protection and working clearance as part of the task, not paperwork that happens somewhere else.
A scenario to discuss
While performing Conduit Bending, Handling & Stored Energy, the crew finds a circuit, cable, box, or temporary-power condition that does not match the label or drawing. Someone says it is probably the same circuit they worked on yesterday. What must be verified before contact or continued work?
Before work starts
- Identify the circuit/equipment and the isolation or protective device that applies to today’s task.
- Inspect cords, plugs, enclosures and temporary wiring in the work area before energizing tools/equipment.
- Establish required working clearances and keep conductive materials/water out of the exposure zone.
- Stabilize mechanical/electric benders and keep hands and feet clear of shoes, rollers and moving conduit.
- Support long conduit so it cannot whip, roll or strike another worker as the bend is made.
Common failure points
- Treating “off” as the same thing as verified de-energized.
- Using damaged or improvised temporary wiring because it still powers the tool.
- Letting water, metal access equipment or another trade move into the electrical clearance.
Safe work sequence / controls
- Stabilize mechanical/electric benders and keep hands and feet clear of shoes, rollers and moving conduit.
- Support long conduit so it cannot whip, roll or strike another worker as the bend is made.
- Use the correct bending shoe, size and setup rather than forcing mismatched material through the machine.
- Release hydraulic or mechanical pressure and isolate power before clearing jams or making adjustments.
Stop and reset the plan if...
- The circuit, conductor or equipment cannot be positively identified or its status is uncertain.
- Cords, plugs, enclosures, GFCI protection or grounding/bonding are damaged or do not match the planned setup.
- Water, metal access equipment, nearby energized work or another condition changes the electrical exposure.
Questions worth asking the crew
- What is energized, what is de-energized, and how was that status verified instead of assumed?
- What GFCI, grounding, isolation, guarding, or other protective device is controlling the electrical exposure today, and how was it checked?
- Where could water, conductive material, damaged cords, or another trade change the electrical risk while we are working?
- What clearance or approach boundary applies here, and how will the crew keep it clear through the whole task?
- Has anyone found a circuit, cord or piece of equipment in a different electrical condition than expected? What clue caught it before contact?
Make it real on the job
Show the disconnect/protective device or test method being relied on and identify the energized boundary.
Close the talk
Before the crew starts, everyone should be able to explain the hazard, point to the control being used today, and name the condition that would make the work stop.
Related authoritative reference
OSHA 29 CFR 1926.300 - Tools · Open reference ↗
This is a practical discussion guide, not a substitute for required training, a competent person, permits, manufacturer instructions, employer procedures, or applicable federal/state/local requirements. Adapt it to the actual task and conditions.
